Skip to content

BSL190 — FormDataToValue method call

← All rules

Summary

FormDataToValue method call

Identifiers

Field Value
Rule code BSL190
Compatible alias FormDataToValue
Severity WARNING
Enabled by default Yes
Implemented Yes
Tags performance, ui

Behavior

  • The public identifier BSL190 and alias FormDataToValue are stable.
  • The rule reports the cases documented on this page.
  • Suppressions and project configuration are applied before publication.
  • The rule requires neither an external analyzer nor network access.

Configuration and suppression

BSL### is the primary stable identifier. The compatible alias is accepted in select, ignore, and compatible block suppression comments.

[tool.onec-hbk-bsl]
select = ["BSL190"]
ignore = ["FormDataToValue"]

All three suppression families support both a current line and a range. When an opening comment follows code, it affects only that line. Use any one form:

  • noqa:
Value = "example";  // noqa: BSL190
  • bsl-disable:
Value = "example";  // bsl-disable: BSL190
  • compatible BSLLS form:
Value = "example";  // BSLLS:FormDataToValue-off

When the same opening comment is on a line by itself, it starts a range. Close it with the matching marker from the same family:

// noqa: BSL190
// code without this diagnostic
// noqa-enable: BSL190

// bsl-disable: BSL190
// code without this diagnostic
// bsl-enable: BSL190

// BSLLS:FormDataToValue-off
// code without this diagnostic
// BSLLS:FormDataToValue-on

To disable the rule until the end of the file, omit the closing noqa-enable, bsl-enable, or BSLLS:…-on marker.

Opening and closing markers must belong to the same family.

Description

In most cases, you should use the FormAttributeToValue method, instead of the FormDataToValue.

The recommendation is due to considerations of unification of the application code and the fact that the syntax of the FormAttributeToValue is simpler than FormDataToValue.

Examples

Procedure Test()
    Form=Doc.GetForm("DocumentForm");
    FD = Form.FormDataToValue(Object, Type("ValueTable"));
EndProcedure

Sources

Source: Using of FormAttributeToValue and FormDataToValue methods (RU)