Skip to content

BSL195 - GetForm method call

← All rules

Summary

GetForm method call

Identifiers

Field Value
Rule code BSL195
Compatible alias GetFormMethod
Severity WARNING
Without configuration Yes
BSLLS JSON, ON mode without overrides Yes
Registry flag implemented Yes
Tags deprecated, ui

The implemented flag describes the registry; it does not certify verified BSLLS parity.

Behavior

  • The public identifier BSL195 and alias GetFormMethod are stable.
  • The rule reports the cases documented on this page.
  • Suppressions and project configuration are applied before publication.
  • The rule requires neither an external analyzer nor network access.

Configuration and suppression

BSL### is the primary stable identifier. The compatible alias is accepted in select, ignore, and compatible block suppression comments.

[tool.onec-hbk-bsl]
select = ["BSL195"]
ignore = ["GetFormMethod"]

All three suppression families support both a current line and a range. When an opening comment follows code, it affects only that line. Use any one form:

  • noqa:
Value = "example";  // noqa: BSL195
  • bsl-disable:
Value = "example";  // bsl-disable: BSL195
  • compatible BSLLS form:
Value = "example";  // BSLLS:GetFormMethod-off

When the same opening comment is on a line by itself, it starts a range. Close it with the matching marker from the same family:

// noqa: BSL195
// code without this diagnostic
// noqa-enable: BSL195

// bsl-disable: BSL195
// code without this diagnostic
// bsl-enable: BSL195

// BSLLS:GetFormMethod-off
// code without this diagnostic
// BSLLS:GetFormMethod-on

To disable the rule until the end of the file, omit the closing noqa-enable, bsl-enable, or BSLLS:…-on marker.

Opening and closing markers must belong to the same family.

Description

To open forms, use the OpenForm global context method (when using the 1C: Enterprise 8.2 platform version and earlier versions, also use OpenFormModal). An alternative method, using the GetForm method, is not recommended.

Examples

Procedure Test()
    Doc = Documents.PlanOperation.CreateDocument();
    Form = Doc.GetForm("DocumentForm"); // here
EndProcedure

Procedure Test2()
    Form = GetForm("CommonForms.MyForm");
EndProcedure

Sources

Source: Development standards (RU)